Search results for 'brake'

Items 1 to 10 of 19 total

per page
Page:
  1. 1
  2. 2

List  Grid 

Set Ascending Direction
  1. Brake Control Rod 41" Kit

    Brake Control Rod 41" Kit

    $8.95

    Out of stock

    This brake control rod is a one-piece rod that can be used to lock your brakes. Tie a brake cable to the end and fit the other end to the brake pedal. Learn More
  2. Brake Cable

    Brake Cable

    $3.95

    Out of stock

    This cable is 56 inch long and has an outer diameter of 5/64 inch . The conduit is 52 inch and conduit caps are installed. One of these will be more than enough for a band brake system! Learn More
  3. Foot Pedal (Brake)

    Foot Pedal (Brake)

    $5.50

    Out of stock

    Any vehicle needs pedals to go and stop. Here are quality pedals that we have been using on our karts for a long time now! They have a stopper built into the pedal as well. You will need to drill a 5/16 inch hole into the frame to mount these pedals. Learn More
  4. 1/4" Clevis

    1/4" Clevis

    $3.80

    Out of stock

    A clevis is primarily used for your brake set up, but when attached to the ends of a rod, they can be used as a makeshift tie-rod. This may be useful in some setups – our Arachnid kart is a great example of this! Learn More
  5. Hydraulic Brake line

    Hydraulic Brake line

    $1.95

    Out of stock

    If the brake line in the hydraulic brake kit isn’t enough for your setup, this is what you need. A friendly reminder that you need double the length from caliper to master cylinder – there are two lines! Learn More
  6. 1" Hydraulic Brake

    1" Hydraulic Brake

    $187.95

    Out of stock

    If you need a little more braking power, this hydraulic brake kit is for you. Made by Martin Custom Products, the full kit has all the components needed to set up a hydraulic brake. Parts included are: Aluminum Brake Caliper with 1-3/8” bore (brake pads included), Aluminum master cylinder ¾” bore, 7” Brake Rotor, 1” Rotor Hub with ¼” keyway and 4 bolt holes on a 3” bolt hole circle, 5’ of hydraulic brake line, and a 4oz bottle of DOT 5 silicon brake fluid. Learn More
  7. 1-1/4" Hydraulic Brake

    1-1/4" Hydraulic Brake

    $187.95

    Out of stock

    If you need a little more braking power, this hydraulic brake kit is for you. Made by Martin Custom Products, the full kit has all the components needed to set up a hydraulic brake. Parts included are: Aluminum Brake Caliper with 1-3/8” bore (brake pads included), Aluminum master cylinder ¾” bore, 7” Brake Rotor, 1” Rotor Hub with ¼” keyway and 4 bolt holes on a 3” bolt hole circle, 5’ of hydraulic brake line, and a 4oz bottle of DOT 5 silicon brake fluid. Learn More
  8. Band Brake for 4-1/2" Drum

    Band Brake for 4-1/2" Drum

    $15.25

    Out of stock

    This low-tech brake is adequate for karts that aren't too fast or don't need overly powerful braking. The band brake comes with a pin, but requires a 4-1/2” brake drum (sold separately). Learn More
  9. Brake Drum, 4-1/2", no Flange

    Brake Drum, 4-1/2", no Flange

    $13.50

    Out of stock

    All drums have 3 sets of mounting holes: 3 & 4 hole on a 3.75" diameter bolt circle and a 4 hole on a 3.228" bolt circle. Learn More
  10. 1" Steel Minihub

    1" Steel Minihub

    $16.95

    Out of stock

    This steel minihub is bolted to a brake drum and fixed to the rear axle by the 1/4" keyway. If you have a band brake, then use this hub with your drum! Learn More

Items 1 to 10 of 19 total

per page
Page:
  1. 1
  2. 2

List  Grid 

Set Ascending Direction